Off-Target Environment
Contents
Overview
Two of the largest barriers to embedded developer productivity are long build/test cycles and scarce target hardware. Fortunately, STRIDE's cross-platform capabilities make it possible to run STRIDE in a host-only "sandbox" that emulates your target system for purposes of evaluation. All of the supplied samples and test code run identically under either the sandbox environment or your actual target. In addition, Any test code you write will also run in either environment.
The sandbox utilizes a "target" application that is built and runs on the host system. The test runner application runs on the same system and communicates with the "target" process over a TCP/IP connection. This set up frees you from external hardware dependencies and provides for rapid build/run cycles.
This article guides you through the steps to run and publish a set of sample tests using the sandbox evaluation environment.
Evaluation Steps
To simplify the evaluation, we recommend using a single Windows or Linux (x86) computer for both the target and host systems. Host and target code will run in separate processes and communicate via TCP/IP, thus simulating an embedded target with host computer configuration. All code and techniques used in the sandbox evaluation are directly transferable to a production environment.
The recommended evaluation steps are as follows:
- Review the STRIDE Overview
- Install required packages
- Activate your STRIDE license
- Configure STRIDE Test Space for publishing results
- Build and test the basic TargetApp with built-in S2 diagnostic tests, publishing results to TestSpace
- Build and test the TargetApp with the TestIntro sample, publishing results to TestSpace
- Create your own test, run and publish
- Explore other sample tests
Installing Packages
The following packages must be installed on the computer you will use for your sandbox environment. (Use Windows or Linux packages as appropriate).
See Package Installation for instructions.
- STRIDE SDK
- Host Tools
- Samples
- Build Tools
Additional Samples
Additional samples are included in the STRIDE Samples package. (See Package Installation for installation information.)
These samples explore each of the techniques outlined in the Test Intro sample in greater depth. See Test Unit Samples for details.
To include any of the samples into your TestApp, just copy the sources into the sample_src and rebuild. To execute the tests, use the stride test runner as before.
